Endress+Hauser iTEMP TMT184 PROFIBUS-PA Manuel De Mise En Service page 65

TMT184
Endress+Hauser
Status process parameter
OUT STATUS
• V6H3
PROFIBUS-PA
PROFILE VERSION
• V6H7
Display of actual error code, See »Application fault messages« on page 75.
ERROR CODE
• V9H0
0
Display of previous error code.
LAST DIAGNOSTIC
• V9H1 Display: See »Application fault messages« on page 75.
0
Display of bus address.
BUS ADDRESS
• V9H4
!
The bus address can only be read in this field. A change of the Bus address using the
software is done via the DPV1 server. The connection to Commuwin II must be 'dis-
connected' before the change of address. (See »Set-up with PROFIBUS« on page 73.)
4
Input:
DEFAULT VALUES
• V9H5 • 1
• 2506 = Warm start
• 2712 = Sets the bus address to 126, when the software addressing is active.
Set-up release code.
SECURITY LOCKING
• V9H9 Input: Lock = 0
Function group: USER INFORMATION
Input and display of measurement point identification (TAG)
TAG NUMBER
• VAH0
Input and display of plant identification
SET USER TEXT
• VAH1
Display of unit version
HARDWARE VERSION
• VAH2
Display of software version
SOFTWARE VERSION
• VAH3
Display of E+H unit serial number
SERIAL NUMBER
• VAH4
®
Profile version 3.0
Function group: SERVICE
Note!
= Sets all values to default
Release = 2457
5 Operation
65