Overflow Drain Hole Cutouts; Installation Instructions For 2-Piece Tub - Jacuzzi Amalia 59 Instructions D'utilisation

Overflow Drain Hole Cutouts

Cutout (Fig. 4)
Linear Drain
Rotary Drain
Avvio Collection
Deep Soak Drain
Slip Cover Drain

Installation Instructions for 2-Piece Tub

Set the 2-piece tub in place and position
1
it precisely with respect to the drain-
overflow location. Verify where the
indentation for the drain is in relation
to the drain-overflow. Use a marker to
outline the perimeter of the entire tub
directly on the floor (Fig. 5).
2 Mark a trough for the overflow drain
location on the floor. The drain-
oveflow extends below the
bottom of the bath. The drain-
overflow requires a cutout of the floor
for providing space to accommodate
the extension. Do not exceed the
dimensions of the tub perimeter.
3
When the above locations have been
marked on the floor, remove the
tub base (skirt), set it aside and
continue with the installation process.
4
Faucetry is not supplied with the
freestanding bath. To use deck-
mounted faucetry, flexible connection
lines that are 72" in length must be
used. These lines need to be installed prior to installating the bath into the skirt.
5
When installing the faucet on the same side as the overflow, make sure there is no interference between the two before
drilling.
Use silicone to attach the tub skirt to the Sub floor. Make sure the tub is properly oriented according to the drain-overflow
6
end. Place the tub skirt on the floor in relation to the drain/overflow. Place the tub skirt on the floor an line up with the
markings prevously made on the floor.
Apply silicone to the foam feet or bottom of the adjustable feet. Carefully place the tub into the tub skirt in relation to the
7
drain/overflow. Allow silicone to dry for 24-hours before entering and/or using the tub.
Page 6
Drain Part Number
MF35XXX
HP55XXX
Integral
LH33XXX
PG35XXX
Silicone
www.jacuzzi.com
Freestanding Baths
Fig. 4
Fig. 3
Fig. 5
Fig. 4
Side
Views
Silicone
Bottom
Views
Installation Instructions