Sennheiser evolution wireless Série Mode D'emploi page 59

Inserting and changing the battery
Slide the cover of the battery compartment
arrow until it clicks audibly and open the cover.
Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity
when inserting the battery.
Close the battery compartment.
Plugging the transmitter onto the microphone
Plug the transmitter's XLR-3 connector
XLR-3 socket.
Tighten the locking ring
Note:
The transmitter uses the microphone body as an antenna – therefore
only microphones with a metal casing should be used for best signal
transmission.
Switching the transmitter on/off
Press the
µ
LED lights up.
To switch the transmitter off, press the
appears on the display. You can then release the button. The red LED
goes off.
µ
Muting the transmitter
Use the MUTE switch
(this switch does not switch off the
.
¾
ON/OFF button to switch the transmitter on. The red
to noiselessly mute the transmitter's audio signal
transmitter).
º
in the direction of the
onto the microphone's
ON/OFF button until "OFF"
61