Bosch PLR 15 Notice Originale page 19

Télémètre laser
Masquer les pouces Voir aussi pour PLR 15:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The rear edge of the measuring tool is preset as the reference plane for the
measurement.
For a wall to wall measurement, as an example, position the measuring
tool with its rear edge against the initial wall.
 Do not point the laser beam at persons or animals and do not look
into the laser beam yourself, not even from a large distance.
"HOLD" Function (see Figure B)
When no button on the measuring tool is pressed for approx. 5 minutes,
the measuring tool automatically switches off to save the batteries.
When a measuring value was held using the "HOLD" function, it is retained
after the automatic shut-off. After switching the measuring tool on again
by pressing the "HOLD" button 2, the previous measuring value e is indi-
cated in the top line of the display.
Bosch Power Tools
Press the "HOLD" button 2 to stop the measur-
ing procedure. The laser beam is switched off
and the HOLD indication appears on the dis-
play. The current measuring value is still dis-
played in the bottom line of the display, but is
no longer continuously updated.
Press the "HOLD" button 2 once more to
switch the laser on again. The LASER indicator
flashes on the display. The previous measuring
value is displayed in the top line. The continu-
ously updated/current measuring value is dis-
played in the bottom line.
Press the "HOLD" button 2 once more to stop
the measuring procedure again. The laser
beam is switched off and the HOLD indication
appears on the display. The previous measur-
ing value is displayed in the top line. The cur-
rent measuring value is displayed in the bot-
tom line, but is no longer continuously
updated.
English | 19
2 609 140 991 | (13.5.13)

Publicité

Table des Matières
loading

Table des Matières