G 2002 Dishwashers - Miele RemoteVision XKM 2000 WLAN Instructions D'installation

G 2002 Dishwashers

RemoteVision module installation
Always disconnect the appliance from the power supply when performing
installation, maintenance or service work.
Install the RemoteVision module before placing the appliance in its installation niche.
The slot for the RemoteVision module is located in the lower area of the back of
your appliance.
^ Push the module into the WLAN slot until it snaps into place.
^ Connect the appliance to the power supply and turn it on. After several seconds
the indicator light will come on.
The indicator light will display different colors one after the other; any control light
at the end indicates that the module was correctly installed.
If the indicator light does not come on, installation of the module was unsuccessful.
In that case, repeat the process. If that does not correct the problem, contact Miele.
^ Angle the antenna so that it faces to the right or left.
^ If necessary, disconnect the power supply and continue installing the appliance.
Appendix
35