Miele RemoteVision XKM 2000 WLAN Instructions D'installation page 32

Appendix
Accessing the RemoteVision
control panel
^ Touch the access button "p" so it
turns yellow.
^ Touch the sensor button for the
refrigerator or freezer section so it
turns yellow.
^ Note the position of the button X, but
do not touch.
^ Touch the access button "p" again so
it turns white.
^ Place one finger on the position of
the X button and hold (the X button
will not be visible).
^ While holding down the X button,
press the access button "p" once.
Keep holding the X button down until
the following appears in the display
(approx. 5 seconds).
Access to the Custom settings mode is
now active for approximately 10
seconds.
32
^ Tap the X button until ; appears in
the display.
^ Touch the access button "p" to
confirm.
See the table on the following page for
a description of each setting in the
display.
^ Use the Y or X buttons to select the
RemoteVision options.
The module has been connected to
the network when ; # appears in the
display.
If ; # does not appear, refer to the
"Network options" section of the
XKM 2000 Installation Instruction
manual.
^ Press the access button "p" to confirm
the setting.
^ To return to the main menu, tap the X
button until a solid ; - appears in the
display.
^ Press the access button "p" to
confirm.
^ Tap the X button until a ; appears in
the display.
^ Touch the access button "p".
You have left the Custom settings
mode.