Connecting The Mini Pak; Connection Icons - RIDGID SeeSnake MINIPak Mode D'emploi

If desired, the front cover and its handle can be used as
a tilt stand for easier viewing.
1. Tilt the unit back slightly and then pull forward on
the front cover latch to free the rotating front cover.
2. Rotate the front cover and front cover handle toward
the bottom of the unit until it latches in place.
Figure 5 – MINI Pak with Tilt Stand Deployed
3. To return the front cover to its horizontal position,
squeeze the front cover handle and latch together to
release, and rotate upward until it latches in posi-
tion.

Connecting the MINI Pak

DC Jack and
Video Port
Figure 6 – DVD Pak Connections
SeeSnake System Cable
Unwrap the SeeSnake System Cable from its holder
and match the System Cable plug to the matching
SeeSnake System Connector on the MINI Pak . To join
the connectors, align the guide pin to the guide socket,
push the connector straight in and tighten the outer
locking sleeve.
NOTE! A guide ridge molded into the top of the cable

Connection Icons

SeeSnake System Connector
Video In Plug
Figure 7 – Connecting System Plug To CCU
SeeSanke
System NOTICE
Connector
system cable, turn only the locking sleeve. To prevent
damage, do not bend or twist the connector or cable.
Battery
External Monitor
Dock
4. The MINI Pak may be used with an external SeeSnake
monitor by connecting an RCA cable from the Video
Transmitter
Clip-on
Out port on the external monitor. Connect the other
Terminal
end of the cable to the yellow MINI Pak video input
port on the back of the MINI Pak , marked with
Ridge Tool Company
SeeSnake ® MINI Pak
connector will point up when the plug is correctly
aligned.
Transmitter Clip-on Terminal
MINI Pak Power Jack
When connecting/disconnecting the SeeSnake
SeeSnake System
Connector
Guide
Ridge
.
7