Bringing The Oven Into Operation Before You Start Cooking; Switching On - Atag OX611T Mode D'emploi

bringing the oven into operation
before you start cooking
cleaning the oven and accessories
Remove the accessories from the oven and clean the
accessories and the inside of the oven with a mild cleaning
agent.
Switch the oven on for an hour at 250 °C (see page 7).
Protective greases used during manufacture will then be
removed.
remark
When your oven is heated strongly for the first time, it will
have a 'new' smell. This is normal. Switch the extractor hood
on if necessary.
After the oven has cooled down, clean it with warm water.
setting the time
The clock shows The clock sets itself. A built-in receiver ensures that the
display always shows the correct time.
Central European
Once you have connected up the oven, it may take a little
Time.
while before there is any reception. During the period when
See also how the
there is no reception or only a disturbed reception, four
clock works on
horizontal lines will appear in the display.
page 25.
You can also set the clock manually.
setting the time manually
1 Check whether the oven is switched off.
2 Press on the time selector switch
clock
starts to blink.
3 Set the correct time using the + and - buttons.
The time will be definitely set a few seconds after you
release the button. After that, the built-in receiver will
automatically keep the time correct (summer and winter
time).
GB 6
until the display

switching on

1 Select an oven function by pressing the appropriate
symbol.
The light above the function selected lights up.
The standard oven temperature appears in the display.
selecting a function The cooking time blinks.
2 Set the temperature required using the + and - buttons.
The temperature can be adjusted in steps of 5 °C.
setting the
temperature
3 Set the cooking time using the + and - buttons.
Cooking time is set in minutes up to 3 hours and 59
minutes.
setting the time
4 Press start.
If you wish, you can still adjust the cooking time.
start
If you forget to press start, the settings you have made will
be erased after one minute and the oven will not start.
during the cooking process
If you do not set a cooking time but do, however, press start,
the oven will still start. You will see the time counting up in
the display.
cooking time counts
up
After the oven has been on for four hours continuously, it
switches off automatically. If stop has been pressed in the
meantime, the clock will start counting again.
The dot after the temperature display goes out when the
oven is at temperature. If the heating elements switch on
again, the dot lights up again.
thermostatic control
operation
switching on
GB 7