Bringing The Oven Into Operation Before You Start Cooking - Atag OX60 E Serie Mode D'emploi

bringing the oven into operation
before you start cooking
cleaning the oven and accessories
Remove the accessories from the oven and clean the
accessories and the inside of the oven with a mild cleaning
agent.
Switch the oven on for an hour at 250 °C (see page 7).
Protective greases used during manufacture will then be
removed.
remark
When your oven is heated strongly for the first time, it will
have a 'new' smell. This is normal. Switch the extractor hood
on if necessary.
After the oven has cooled down, clean it with warm water.
setting the time
If you have not set a 1 There is a normal clock on the display that shows the
time, 0.00 and the time. Press the
word "AUTO" will
blink. 2 Press the –/+ buttons until the correct time is reached.
"AUTO" keeps blinking.
3 Press the
The time has been set and the appliance is set to manual
control.
clock
GB 6
| and buttons at the same time.
,
button.
switching on without the clock
,
1 Press the button to set the oven to manual control.
The "hand" symbol can be seen in the display.
2 Select an oven function by turning the knob to the
required symbol.
selecting a function
The oven has not yet been switched on.
3 Select the temperature required.
The temperature is continuously adjustable.
The oven has now been switched on.
setting the
temperature
timer
The timer only gives a signal when the time has elapsed. It
does not switch the oven off.
Press the .button and keep it pressed.
1
@
0.00 and light up.
setting the time 2 Set the time with the –/+ buttons.
. lights up. The time appears five seconds after release
of the button.
operation
switching on
GB 7