Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
Troubleshooting
If you suspect something is wrong, immediately switch power off. Do not use the unit in abnormal condition,
for example without sound, or with
smoke or foul smell, can cause fire or electric shock. Immediately stop using it and call the store where you
purchased it. Never try to repair the unit
yourself because it is dangerous to do so.
General
No power or no sound. Car's engine switch is not on. Turn your car's key to ACC or ON. Cable is not
correctly connected. Check connection.
Fuse is blown. Replace fuse. Check volume or mute on / off. If the above solutions cannot help. Press
the RESET button.
Check that telephone mute input cable is not been trapped and grounded during installation.
Disc
Disc is inside but no sound. Disc is upside down. Place disc in the correct direction, and the label side
up. Disc is dirty or damaged. Clean disc or change another disc. Disc sound skips, tone quality is low.
Disc is dirty or damaged. Clean CD or change another CD.
Sound skips due to vibration. Mounting angle is over 30o. Adjust mounting angle to less than 30o.
Unstable mounting. Mount the unit securely with the mounting parts.
Radio
Noise in broadcasts. Station is too far, or signals are too weak. Select other stations of higher signal
level.
Preset station lost. Battery cable is not
correctly connected. Connect the battery cable to the terminal that is always live.
Error Display Messages
Display shows ERROR. Disc is dirty, damaged or upside down. Press
to eject the disc.
When video file initializing time is too long.
File read error or file type not supported.
Press SRC to exit. Then press SRC to play disc again
Should the suggested solutions be in vain, press RESET.
61
Publicité
Table des Matières
