Belkin F5D7230-4 Manuel De L'utilisateur page 91

Manually Configuring Network Settings
4.
Select the "TCP/IP" tab
see "Manually" or "Using DHCP". If you do not, check the
(5)
PPPoE tab
selected. If it is, you will need to configure your Router for a
PPPoE connection type using your user name and password.
5.
If "Manually" is selected, your Router will need to be set up for
a static IP connection type. Write the address information in
the table below. You will need to enter this information into the
Router.
6.
If not already selected, select "Using DHCP" next to "Configure:"
(4)
, then click "Apply Now".
Your network adapter(s) are now configured for use with the Router.
(3)
. Next to "Configure:"
to make sure that "Connect using PPPoE" is NOT
(4)
89 89
, you should
1
2
3
4
5
6
7
8
9
10