Belkin F5D7230-4 Manuel De L'utilisateur page 88

Manually Configuring Network Settings Manually Configuring Network Settings
Set up the computer that is connected to the cable or DSL modem
FIRST using these steps. You can also use these steps to add
computers to your Router after the Router has been set up to connect
to the Internet.
Manually Configuring Network Adapters in Mac OS up to 9.x
In order for your computer to properly communicate with your Router,
you will need to change your Mac computer's TCP/IP settings to
DHCP.
1.
Pull down the Apple menu. Select "Control Panels" and
select "TCP/IP".
2.
You will see the TCP/IP control panel. Select "Ethernet Built-In"
or "Ethernet" in the "Connect via:" drop-down menu
(1)
(2)
3.
Next to "Configure"
will need to be set up for a static IP connection type. Write the
address information in the table below. You will need to enter
this information into the Router.
4.
If not already set, at "Configure:", choose "Using DHCP
Server". This will tell the computer to obtain an IP address
from the Router.
(2)
, if "Manually" is selected, your Router
86 86
(1)
.