Steba VK 4 Mode D'emploi page 11

Before initial use:
∙ Wipe off the device with a damp towel.
∙ The sealing rings and the bag sealing bar must be clean and level, otherwise it will
not be possible to generate a vacuum.
Cleaning
∙ Unplug the device and leave to cool down.
Do not immerse the device in water or pour water
∙
over it.
∙ For hygienic reasons, the device must be cleaned after every
use.
∙ Remove the lower seal and the lower contact seal out of the va-
cuum chamber and clean in warm soapy water and leave to dry.
∙ Wipe the other parts with a damp cloth with detergent and
dry. Do not use abrasive detergents.
∙ "Achtung" Ensure that the upper welding strip and the upper
seal are not damaged.
∙ Carefully install the lower two seals.
∙ Ensure that no liquids enter the vacuum extractor when clea-
ning.
Roll of film / bags
Use only the special rolls of film / plastic bags that are suitable for vacuuming and
sealing. If the wrong film is used it will stick to the device and damage the sealing bar.
The following special films are available from Steba, among other things:
Plastic bags: 22 x 30cm:
Plastic bags: 28 x 40cm:
Roll of film: 20 x 600cm: Item no. 93-26-00
Roll of film: 28 x 600cm: Item no. 93-36-00
Item no. 93-20-00
Item no. 93-24-00
EAN: 4011833400888
EAN: 4011833400895
EAN: 4011833400901
EAN: 4011833400918
11