Connecting The Cuff To The Monitor; Applying The Cuff - Gima KD-558 Manuel De L'utilisateur

Picture 2
b. While the monitor is in Clock Mode, pressing both the "START" and
"MEM" button simultaneously, a beep is heard and the month will blink
at rst. See picture 2-2. Press the button "START" repeatedly, the day,
hour and minute will blink in turn. While the number is blinking, press
the button "MEM" to increase the number. Keep on pressing the button
"MEM", the number will increase fast.
c. You can turn off the monitor by pressing "START" button when the minute
is blinking, then the time and date is con rmed.
d. The monitor will turn off automatically after 1 minute of no operation,
with the time and date unchanged.
e. Once you change the batteries, you should readjust the time and date.

3. Connecting the cuff to the monitor

Insert the cuff tubing connector into the socket in the left side of the monitor.
Make certain that the connector is completely inserted to avoid air leakage
during blood pressure measurements.
Avoid compression or restriction of the connection tubing during
measurement which may cause in ation error, or harmful injury due to
continuous cuff pressure

4. Applying the cuff

a. Pulling the cuff end through the medal loop
(the cuff is packaged like this already), turn it outward
(away from your body) and tighten it and close the
Velcro fastener.
All manuals and user guides at all-guides.com
ENGLISH
Picture 2-1
28
Picture 2-2