LaserLiner SuperLine-Laser 360 Mode D'emploi page 9

Horizontal and vertical levelling
2
Release the transport restraint, set slide switch (3) to „ON". The horizontal laser line appears.
The laser lines can be switched individually with the selection button.
LASER LASER
The transport restraint must be released for horizontal and vertical levelling. The laser lines flash
!
when the device is outside the automatic levelling range of 3°. Position the device such that it is
within the levelling range.
Slope mode
3
Do not release the transport restraint, set slide switch (3) to the mid-position and select the lasers
with the selector switch. Sloping planes and tilts can now be measured. In this mode, the laser lines
no longer align automatically. This is signalised by the laser lines flashing.
LASER LASER
Hand receiver mode
4
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out levelling at great
distances or when the laser lines are no longer visible.
To work with a laser receiver, switch the line laser to hand-held receiver
mode by keeping button 5 (hand-held receiver mode on / off) pressed.
The laser lines will now pulsate with high frequency, making the laser
lines darker. The laser receiver can detect these pulsating laser lines.
!
Follow the operating instructions of the corresponding laser receiver.
LASER LASER
LASER LASER
SuperLine-Laser 360°
LASER
LASER
09
EN