Assembling The Vacuum Cleaner - ARIETE Vertigo 2781 Mode D'emploi

GB
DO NOT THROW AWAY THESE INSTRUCTIONS
DESCRIPTION OF THE APPLIANCE (FIG.1)
1 Bag full indicator
2 On/Off switch
3 Suction power regulation
4 Cord rebwind switch
5 Carry handle
6 Dust bag compartment
7 Dust bag compartment release switch
8 Flexible nozzle
9 Crevice nozzle
10 Extension tube
11 Hand grip
12 Suction control
13 Floor brush
14 Hard floors/carpet selector

ASSEMBLING THE VACUUM CLEANER

Insert the nozzle connector into the nozzle compartment and turn it clockwise until it locks into
place (FIG. 2). To remove the nozzle connector, turn it anticlockwise and remove it from its seat.
CAUTION: Before fitting or removing attachments, always make sure that the vacuum cleaner has
been unplugged from the mains power.
ATTACHMENTS
Extension tube
Insert the extension tube into the hand grip and then fit the required attachment.
Once this attachment is inserted, it is possible to lengthen the extendible tube as required, using the
relevant flick lever (FIG. 3). Release the lever to lock the tube in the required position.
Floor brush (13)
This is used for cleaning large areas and to reach any corner with ease.
b Cleans rugs and carpets without the need for a brush attachment. Press the tip switch marked
with the carpet symbol
b Smooth flooring, such as PVC, parquet or tiles, is best cleaned and cared for if the brush attachb b
ment is used. Press the tip switch with the smooth floor symbol
come out.
Crevice nozzle (9)
This attachment can be used in place of the floor brush. Fit it directly to the hand grip to use it
directly or place it on the extension tube when cleaning areas that are more difficult to reach.
and this will raise the brush.
b 6 b
and the brush will