Using The Appliance - ARIETE SMART 2000 W Mode D'emploi

EN
Narrow suction nozzle with brush (I)
This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that
are impossible to reach using the floor cleaning device. This attachment can also be fitted directly to
the handle (N).

USING THE APPLIANCE

CAUTION: Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid
any possible damage to the cleaner itself.
First of all, before using this appliance, unwind the power cord fully and plug it in. To switch on, press
the On/Off switch on the vacuum cleaner (FIG. 4).
IMPORTANT: Sometimes the appliance will make a whistling sound when switched on; this is not a
defect and will gradually go away with use.
Suction control
The secondary air valve (O) is located on the handgrip and it is used to adjust suction power
(FIG. 5).
- The larger the valve opening, the lower the suction power and vice versa.
- To open the valve, push the lever upwards and to close it, push the lever downwards.
Valve adjustment depends on the type of surface:
- Minimum power for curtains and delicate materials.
- Medium power for pillows and cushions, mattresses and carpets.
- Maximum power for floors in tiles, wood or other strong, hardwearing and heavily soiled materials.
CAUTION: Switch off the vacuum cleaner immediately if the air openings, brushes or telescopic tubes
become blocked. Remove the obstruction before switching the vacuum cleaner on again.
After using the cleaner
After use, switch off the vacuum cleaner using the pedal switch (E), unplug it from the mains power
and wind in the cord by pressing the cord winder pedal (C) on the appliance. The cord will wind inside
the appliance container.
IMPORTANT: While winding the power cord, guide it with one hand so as to prevent injury and take
care in the presence of children or pets.
- The appliance can be stored using the special rear hook for the floor brush (FIG. 6).
CLEANING AND MAINTENANCE
CAUTION: Before carrying out any cleaning or maintenance operation, switch off the appliance and
remove the plug from the mains socket.
Replacing the dust bag
When the indicator light shows red, then it is time to change the dust bag.
- lift the bag compartment by pushing the relevant lever outwards (FIG. 7);
- Take out the bag (FIG. 8), being careful not to tear it: slide the stiff card section out along the
guides and then throw the bag away;
- 10 -