Indel B TB 20 BT DT Instructions D'utilisation page 19

OFF-S E T VALU E
This is the information needed to align the temperature shown on the display with the actual
temperature inside the refrigerated compartment. Each off-set can be adjusted within a range of
from -10 to +10.
After running the refrigeration system for a few hours, place a digital thermometer (not supplied)
inside the compartment, in a location where a more accurate temperature is required, and check
that the temperature shown on the display coincides with the temperature shown on the digital
thermometer. If the temperature is not the same, the off-sets must be adjusted in relation to the
temperature T you want the inside of the compartment to reach, so that the temperature reading
on the display coincides with the temperature indicated by the thermometer.
The following table shows the factory off-set setting for each temperature range and the
adjustment range for changing these settings.
OFF-SET FUNCTION
Set temperature≥0 °C, temperature
F1
compensation value
-1°C≥Set temperature≥-14°C,
F2
temperature compensation value
Set temperature≤-15°C, temperature
F3
compensation value
• When the fridge is switched off, keep pressed for 3 seconds the two left-bin buttons "∧" and
"∨" at the same time to enter the temperature compensation mode.
• In the temperature compensation setting mode, the display will show F1/F2/F3. Press the
ON/OFF button to switch from an off-set value to the following one. The display will show
before the off-set values of the left-bin, then the off-set values of the right-bin.
• Press the lighted "∧" and "∨" buttons to set the selected parameter.
• The default off-set values are shown above.
FILLING
Do not put hot food items into the refrigerator. Place the products in such a way as to avoid them
hitting against each other or breaking because of the movement of the vehicle.
Make sure that the lid is always well closed and open it for as short a time as possible.
DEFROSTING
Defrosting is needed when the layer of frost is thicker than 4 mm. To carry out this operation, turn
off the refrigerator. Do not use sharp or cutting tools to remove the layer of frost or ice. Wait until
complete unfreezing and then turn on again.
VALUE DEFAULTED WHEN SHIPMENT
LEFT BIN
0°C
0°C
0°C
17
RIGHT BIN
0°C
0°C
+2°C