Log Placement - Continental Fireplaces CDI-30N Instructions D'installation Et D'opération

14
4.5

LOG PLACEMENT

EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
TM
PHAZER logs and glowing embers exclusive to Continental®, provide a unique and realistic glowing effect that
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing
effect.Log colours may vary. During the initial use of the appliance, the colours will become more uniform as
colour pigments burn in during the heat activated curing process.
A. Place the back log (#1)
onto the log support tray
and in front of the tabs.
The tabs maintain an
air space between the
log and fi rebox back to
facilitate combustion air
fl ow. Ensure that the
back of the log rests
against the brackets
on the back wall of the
fi rebox.
D. Position the base end of
the center log (#5)against
the middle grate post with
the other end of the log
resting in the pocket of the
left crossover log.
W415-1405 / A / 01.06.16
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
B. Move the two small
logs (#2 & #3) into
position, lining up the
studs located on the
burner with the holes
on the bottom of the
logs. Ensure that the
small logs sit fl at on the
burner.
E. Place the bottom of the
right crossover log (#6)
against the right fi rebox
side and pulled forward
to the grate. The top of
the log should rest in
the pocket provided on
the center log (#5).
WARNING
!
C.
76.1A
Place the bottom of the
left crossover log (#4)
against the left fi rebox
side and pulled forward
to the grate. The top of
the log should rest in the
pocket on the back log.