Installation Of The Appliance; Requirements For The Installation; Electrical Connection - CASO DESIGN EMCG 32 Mode D'emploi Original

Returning the packaging back to the material loop saves raw materials and
reduces the quantities of accumulated waste. Take any packaging materials that
are no longer required to "Green Dot" recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

11.5 Installation of the appliance

11.5.1 Requirements for the installation:

 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 Ensure that the power cable does not hang down over a table or counter edge.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
 Place the microwave appliance as far away from radios of TVs to minimize any
interference to radio and TV reception.
 This appliance is only intended for domestic use.
 This oven is intended for built-in use only. It is not intended for counter-top use or for
use inside a cupboard.

11.5.2 Electrical connection

DANGER: Risk of electrocution
► Touching internal compponents may cause serious, severe and fatal injuries.
► Do not disassemble the appliance.
► Improper grounding can cause electrical shocks. Do not use a power outlet if it is not
properly installed and grounded.
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device
If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers.
 Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
caso EMCG 32 53