Avoiding Radio Interference; Assembling The Accessories; Glass Turntable; Grating - CASO DESIGN EMCG 32 Mode D'emploi Original

Please note
► Install or locate this oven only in accordance with the installation instructions provided.
► The outside surfaces of the cabinet may get hot.

11.5.4 Avoiding radio interference

The device can cause the occurrence of interference in radios, televisions or similar
devices.
Such faults can be rectified or reduced as a result of employing the following measures:
 Clean the door and the sealing surfaces of the device.
 Set the radio, the television, etc as far as possible away from the device.
 Connect the device to a different electrical outlet, so that various power circuits are used
for the device and the receiver with the interference.
 Use a properly installed antenna for the receiver, to ensure good reception.

11.6 Assembling the accessories

11.6.1 Glass turntable

1 Hub (underside)
2 Glass turntable
3 Turntable drive
4 Rolling ring
Assemble the glass turntable as follows:
 Insert the rolling ring
 Place the glass turntable inside the appliance so that the grooves on the underside of
the glass dish lock into the turntable drive.
 Never place the glass tray inside the appliance upside down; it must be able to revolve
freely.
 When cooking always use the glass turntable and the matching rolling ring.
 Always place all food and containers on the glass turntable or the grating for grilling.
 In case the glass turntable or the rolling ring crack or break please contact your Service
Centre.

11.6.2 Grating

 Place the grating on the glass turntable.
► Use the grating only for grilling, convection and combination operation C3.
caso EMCG 32 55