Tips On Energy Saving; Frost Protection - Thermador TCM24PS Mode D'emploi

en

Tips on energy saving

Clean & Descale
Takes about 26 minutes.
Clean & Descale combines the functions
Descale and Clean. If both programs are
due to be carried out close together, the
fully automatic coffee machine will auto-
matically suggest this service program�
● Press E�
● Select "Clean & Descale" with the K or
L arrow button.
● Press C� The display
indicates the progress of the program�
● Clean and re-insert the beverage outlet,
empty, clean and re-insert the drip tray
with drain filter and coffee grounds
container�
● Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer�
● Remove the water filter (if there is one)
and press C�
● Pour lukewarm water into the empty
water tank up to the "0.5 l" mark and then
dissolve one Thermador descaling tablet
00311820 in it�
Note:
If there is not enough descaling solution in
the water tank, you will be asked to do the
following. Refill using uncarbonated water
and press C again�
● Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container�
● Close the appliance door�
● Press C�
The program will now run for about
19 minutes�
● Replace the water filter (if removed).
● Replace the water tank and close the
door�
● Press C�
The program will now run for about
7 minutes and rinse the appliance�
● Press C� The appliance
is descaled, cleaned and ready for use
again�
● Press E to exit the program�
28
Special rinsing
NOTICE:
If any of the service programs are ever
interrupted, for instance by a power failure,
please proceed according to the informa-
tion on the display:
● Press C� The program will
now run for about 2 minutes and rinse the
appliance�
● Press E to exit the program�
Tips on energy saving
● Press I to switch the appliance
to "energy saving mode". The appliance
uses very little power when in "energy
saving mode", but monitors all safety-
relevant functions as to avoid damage�
● In the menu under "Switch off after",
set the automatic switch off period to
15 minutes�
● Reduce the brightness of the display
and the illumination in the menu to save
energy�
● If possible, do not interrupt the dispensing
of coffee or milk froth. Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly�
● Descale the appliance regularly to avoid a
build-up of limescale. Limescale residues
cause higher energy consumption�

Frost protection

To prevent frost damage during transport
and storage, completely empty the appli-
ance beforehand (see the section "Menu –
Frost protection").