Controls; Initial Use - Thermador TCM24PS Mode D'emploi

en

Controls

Controls
The appliance features user-friendly menu
navigation to ensure that operation is as
easy as possible while at the same time
offering a wide range of functions. That
means a range of options can be selected
with just a few operating steps�
Power switch J
The power switch J (with the door
open) is used to switch on the appliance or
switch it off completely (power supply is
interrupted)�
NOTICE:
Do not press the power switch while the
appliance is in use� Switch off the appli-
ance only when it is in energy saving mode,
so that it can rinse automatically�
Control panel (touch field)
Navigate on the control panel by pressing
the symbols and characters.
You will hear an audible signal. The audible
signal can be switched on and off (see the
section "Menu – Key press sound").
I
Press I to switch on the
appliance or put it into energy saving mode�
The appliance is rinsed automatically�
The appliance does not rinse:
● if it is still warm when switched on, or
● if no coffee was dispensed before it was
switched off.
The appliance is ready for use as soon as
the symbols for the drinks selection appear
on the display�
A
Press A to go to menu� Settings
can be reconfigured, and able to retrieve
information� It can also connect the
appliance to Home Connect�
E
Press E to view the selection of
service programs� Then select the desired
program as described in the section
"Service Programs."
8
G
Press G after selecting a drink to
prepare two cups simultaneously (see the
section "Two cups at once").
B
Press B to open the selection
of "Personalized beverage preparation".
Personal settings for coffee drinks can
be saved and called up (see the section
"Personalized drinks").
C
Press C to prepare a
beverage or to launch a service program.
Note:
If you press C again while
the drink is being prepared, dispensing will
be prematurely halted.
Arrow navigation button
Press the arrows to navigate the display or
to change the parameters�
Display
The display shows drinks, settings and
information (see the section "Display").

Initial use

General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans. Do not use coffee beans
that have been glazed, caramelized or
treated with other additives containing
sugar, since they will block the brewing unit.
¡
WARNING
Before the appliance can be switched on
and used, it must be assembled and
connected according to the enclosed
assembly instructions.
Setting up the appliance
● Remove any protective plastic film.
NOTICE:
Only use the appliance in a frost-free
room. If it has been transported or stored
at temperatures below 32°F, wait at least
3 hours before initial use.