Tips On Energy Saving; Frost Protection - Thermador TCM24RS Manuel D'utilisation

en
● Pour lukewarm water into the empty
water tank up to the "0�5 l" mark and then
dissolve one Thermador descaling tablet
00311823 in it�
Note:
If there is not enough descaling solution in
the water tank, you will be asked to do the
following� Refill using uncarbonated water
and press C again�
● Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container�
● Close the appliance door�
● Place a container with a capacity of 17 oz
under the beverage outlet�
● Press C�
The program will now run for about
19 minutes�
● Remove the container and press
C�
● Rinse the water tank and (if removed)
replace the water filter.
● Fill the tank with fresh water up to the
"max" indicator�
● Replace the water tank and close the
door�
● Place the container underneath the
beverage outlet again�
● Press C�
The program will now run for about
7 minutes and rinse the appliance�
● Remove the container, empty the drip
trays, replace and close the appliance
door�
● Press C� The appliance
is descaled, cleaned and ready for use
again�
● Press E to exit the program�
Special rinsing
NOTICE:
If any of the service programs are ever
interrupted, for instance by a power failure,
please proceed according to the informa-
tion on the display:
● Rinse the water tank and refill it with fresh
water up to the "max" mark�
● Press C� The program will
now run for about 2 minutes and rinse the
appliance�
● Empty the drip trays, replace and close
the appliance door� The appliance is
ready for use again�
● Press E to exit the program�

Tips on energy saving

● Press I to switch the appliance
to "energy saving mode"� The appliance
uses very little power when in "energy
saving mode", but monitors all safety-rel-
evant functions so as to avoid damage�
● In the menu under "Switch off after",
set the automatic switch off period to
15 minutes�
● Reduce the brightness of the display
and the illumination in the menu to save
energy�
● If possible, do not interrupt the dispensing
of coffee or milk froth� Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly�
● Descale the appliance regularly to avoid a
build-up of limescale� Limescale residues
cause higher energy consumption�

Frost protection

To prevent frost damage during transport
and storage, completely empty the appli-
ance beforehand (see the section "Menu –
Transport protection")�
27