en
Simple troubleshooting
Problem
Protective cover of the
brewing unit cannot be
properly attached�
There is water under the
drip tray�
Display shows
"12:00"
Display shows
"Milk container connected?"
despite connected milk
container�
Display shows
"Overvoltage or
undervoltage"
Display shows
"Leave device to cool"
Display shows, for example:
"Fault: E0510"
Display shows
"Fill bean container"
although the container is
already full, or the grinder is
not grinding any beans.
Display shows
"Clean brewing unit"
Display shows
"Remove filter"
32
Cause
Brewing unit is not locked�
This water is condensation�
Power failure or appliance
switched off at power switch.
Container is outside the range
of the sensor�
Material e�g� milk carton is not
recognised�
Voltage too high or too low�
Appliance is too hot�
The appliance has a fault�
Beans are not falling into the
grinding unit (beans too oily).
Brewing unit is soiled�
Too much ground coffee in the
brewing unit.
The mechanism of the
brewing unit is stiff.
New water filter not rinsed
according to instructions, or
water filter used or defective.
Air in the water filter.
Solution
Lock the brewing unit, see the
section "Cleaning the brewing
unit".
Do not insert drip tray without
cover�
Re-enter values; do not switch
the appliance off at the power
switch or select the "Off" option in
the Clock display menu�
Position the container at the right
edge�
Confirm the display request with
"yes" or use the enclosed milk
container�
Contact electricity or grid
provider� Have the power supply
checked by an expert.
Switch off appliance for
30 minutes�
Proceed according to the display
screen�
Gently tap the bean container.
Possibly change the type of
coffee. When the bean container
is empty, wipe it with a dry cloth�
Clean the brewing unit.
Clean the brewing unit. Do
not place more than two level
measuring spoons of ground
coffee in the drawer.
Clean the brewing unit, see
the section "Care and daily
cleaning".
Rinse the water filter according
to the instructions and then
switch on, or use a new water
filter.
Dip the water filter into water
until no more air bubbles escape,
replace the filter.