Shindaiwa EB630 Manuel D'utilisation page 7

Assembling the Blower (EB630RT)
IMPORTANT!
This unit is equipped with a static dis-
charge reduction wire. This wire helps
direct static buildup into the air stream
reducing the felt amount to the operator.
1. Place the blower upright on the ground
or a sturdy work surface and note parts
orientation as shown in figure 7.
2. Remove static wire from package and
fix eyelet to right hand engine cover
screw. See Figure 8.
3. Turn the dicharge tube out to a right
angle and slip anti-static wire through
the 100mm clamp and flexible tube.
4. Slip the flexible tube over the end of the
90° discharge tube, and secure with the
100mm clamp.
NOTE:
Check to make sure that the 90
tube swivels freely from front to back. If any
binding is present, loosen 100mm clamp and
pull wire towards engine to get more slack
and recheck for free movement.
5. Slide the throttle assembly over the
swivel tube. Do not tighten clamp at this
time.
6. Insert the static wire through the swivel
tube, then install and tighten the 85mm
clamp over the rotating band on the
swivel tube.
7. Fold the end of the static wire back over
the connection of the swivel tube.
See Figure 8.
8. Grasp the straight tube, and push the
tube over the swivel tube locking pins
securing the static wire. See Figure 9A.
9. Lock the straight tube to the swivel tube
by rotating the straight tube.
10.Grasp the nozzle tube and lock the
nozzle to the straight tube noting the
alignment marks. See Figure 9B.
11.Install throttle cable holder just forward
of the 100mm clamp. See Figure 10.
12.Adjust throttle assembly for best
operator comfort and tighten two
socket-head screws.
Anti-Static
Wire
Figure 7
0 discharge
Static Wire
Connector
Figure 8
Figure 10
Flexible Tube
90° Discharge
Tube
100mm
Clamp
Throttle
Assembly
Fold Wire
Swivel
Tube
Flexible Tube
Static Wire
Throttle Cable Holder
Swivel
Tube
Straight
85mm Swivel
Clamp Tube
Align the lock pins with the
lock slots, and push the
A
Lock Pin
Lock Slot
Rotate clockwise to lock
making sure the 3 lines are
aligned on both tubes.
English
B
Figure 9
IMPORTANT!
Blower tube installation affects blower
performance! Make sure the tubes and
nozzle are correctly assembled per
above, and that all connections are tight.
Blower tubes may come apart during use
unless tubes are aligned and locked into
place.
WARNING!
Danger from rotating impeller!
Stop the engine before installing or
removing the blower tubes! Never
perform any maintenance or
assembly procedures on this unit
while the engine is running!
Throttle
Assembly
Nozzle
Tube
630RT15
tubes together.
7