Maintenance - Shindaiwa EB630 Manuel D'utilisation

Maintenance

IMPORTANT!
MAINTENANCE, REPLACEMENT OR
REPAIR OF EMISSION CONTROL DE-
VICES AND SYSTEMS MAY BE PER-
FORMED BY ANY REPAIR ESTABLISH-
MENT OR INDIVIDUAL, HOWEVER,
WARRANTY REPAIRS MUST BE PER-
FORMED BY A DEALER OR SERVICE
CENTER AUTHORIZED BY SHINDAIWA
KOGYO CO., LTD. THE USE OF PARTS
THAT ARE NOT EQUIVALENT IN PER-
FORMANCE AND DURABILITY TO
AUTHORIZED PARTS MAY IMPAIR THE
EFFECTIVENESS OF THE EMISSION
CONTROL SYSTEM AND MAY HAVE A
BEARING ON THE OUTCOME OF A
WARRANTY CLAIM.
Daily Maintenance
WARNING!
To reduce fire hazard, keep the engine
and muffler free of dirt, debris, and
leaves.
Every 10 Hours
(more frequently in dusty conditions)
1. Remove the air cleaner cover by
loosening the thumb screw and lifting
up. See Figure 21.
2. Remove and inspect the pre-filter. If the
pre-filter is torn or otherwise damaged,
replace it with a new one.
3. Clean the pre-filter with soap and water.
Let dry before reinstalling.
4. Inspect the air cleaner element. If the
element is damaged or distorted,
replace it with a new one.
IMPORTANT!
The EB630 uses a special high capacity
dry-type air filter element. The filter
should not be cleaned with a liquid
cleaner and must NEVER be oiled!
5. Tap filter gently on a hard surface to
dislodge debris from element or use
compressed air from the inside to blow
debris out and away from the air filter
element.
WARNING!
Before performing any maintenance,
repair or cleaning work on the unit,
make sure the engine is completely
stopped. Disconnect the spark plug
wire before performing service or
maintnenance work.
CAUTION!
The engine is cooled by air drawn into
the air intake cover on the blower
housing. The blower fan then pushes
the cooling air through an opening in
the fan housing, forcing it past the
cylinder cooling fins. Failure to keep
the cooling system and its passages
clear of debris will likely result in
engine overheating, a major cause of
serious engine problems that can lead
to failure.
Cover
Cover Latch
Thumb
Screw
Figure 21
IMPORTANT!
Direct the air stream at the inside face of
the filter only!
6. Install the filter element, pre-filter and
cover in the reverse order of removal.
WARNING!
Non-standard parts may not operate
properly with your unit and may cause
damage and lead to personal injury.
Using non-standard replacement parts
could invalidate your Shindaiwa warranty.
Prior to each workday, perform the
following:
■ Remove all dirt and debris from blower
exterior and the engine. Check the
cooling fins and air cleaner for clogging
and clean as necessary.
■ Inspect the engine, tank, and hoses for
possible fuel leaks, and repair as
necessary.
■ Inspect the entire blower for loose,
damaged, or missing components, and
repair as necessary.
English
■ Carefully remove any accumulations of
dirt or debris from the muffler and fuel
tank. Dirt build-up in these areas can
lead to engine overheating, fire or
premature wear.
Air Cleaner
Pre-Filter Element
To remove the cover, loosen the thumb
screw on the bottom and lift up.
CAUTION!
Never operate the blower if the air
cleaner assembly is damaged or
missing!
NOTE:
11