Blade Sharpening - BaByliss PRO FX880E Mode D'emploi

the top of the clipper blade, and
then pull down and over the back
of the blade. To remove, pull up on
the back of the comb attachment
and then pull away from the blade.
REPLACEMENT (REMOVAL)
OF BLADE SET
Step 1. Unplug the unit and adjust
the taper lever (see illustration A).
Step 2. Remove the screws and the
fixed blade. Save the screws.
Step 3. Lift off the small moving
Taper Lever
A.
C.
Fixed Blade
Still Moving Blade
blade (with white blade driver), re-
place it with a new one. Align the
spring with the spring hole and ac-
commodate the metal driving pin
into the slot from the white blade
driver (see illustration B).
Step 4. Replace the fixed blade us-
ing the screws and lightly tighten
them. Adjust the teeth as shown in
illustration C, to a gap of 1 mm to
1.5 mm and the small moving blade
as centered and parallel as possible
to the fixed blades teeth.
IMPORTANT NOTE:
The top edge of the fixed blade
must be a minimum of 1 mm higher
than the top edge of the moving
blade as centered as possible. This
is important so that the moving
blade does not come in contact
Spring Hole
White Blade Driver
Metal Driving Pin
B.
1-1,5mm
8
with the skin.
Be sure to add a few drops of
BaBylissPRO® lubricating oil to the
blades before running.
Don't forget to tighten the screws
after the blades have been aligned.

BLADE SHARPENING

BaBylissPRO® cutting blades are
ground from the finest quality steel
with carbon and are hardened to
extend the cutting performance.
As with any cutting appliance, the
cutting edges become dull from
repeated usage.
Increasing blade tension to force
the blade cutting that would cause
the clipper to overheat and reduce
its motor life.
When the blade no longer cuts
smoothly, replace it with a new
BaBylissPRO® blade set.
9