Performance Data Sheet - Cafe CFE Manuel D'utilisation Et D'installation

Performance Data Sheet Model: RPWFE
performance data sheet and at iapmort.org.
Substance Tested for Reduction
Chlorine Taste and Odor 2.0 mg/L +/- 10%
Chloramine Taste and Odor 3.0 mg/L +/- 10%
Particulate, Class I At least 10,000/mL
Cysts 50,000/L
Lead 0.15
Mercury 0.006
Asbestos 107 to 108 fibers/ L
Toxaphene
VOC (Chloroform surrogate chemical) 0.300
Alachlor 0.050
Atrazine 0.100
Benzene 0.081
Carbofuran 0.190
carbon tetrachloride 0.078
chlorobenzene 0.077
chloropicrin 0.015
2,4-D 0.110
dibromochloropropane (DBCP) 0.052
o-Dichlorobenzene 0.08
p-Dichlorobenzene 0.040
1,2-dichloroethane 0.088
1,1-dichloroethylene 0.083
cis-1,2-dichloroethylene 0.170
trans-1,2-dichloroethylene 0.086
1,2-dichloropropane 0.080
cis-1,3-dichloropropylene 0.079
dinoseb 0.170
Endrin 0.053
Ethylbenzene 0.088
ethylene dibromide (EDB) 0.044
bromochloroacetonitrile 0.022
dibromoacetonitrile 0.024
dichloroacetonitrile 0.0096
trichloroacetonitrile 0.015
1,1-dichloro-2-propanone 0.0072
1,1,1-trichloro-2-propanone 0.0082
heptachlor (H-34, Heptox) 0.025
heptachlor epoxide 0.0107
hexachlorobutadiene 0.044
hexachlorocyclopentadiene 0.060
Lindane 0.055
methoxychlor 0.050
pentachlorophenol 0.096
simazine 0.120
Styrene 0.150
1,1,2,2-tetrachloroethane 0.081
Tetrachloroethylene 0.081
Toluene 0.078
2,4,5-TP (silvex) 0.270
tribromoacetic acid 0.042
1,2,4-Trichlorobenzene 0.160
1,1,1-trichloroethane 0.084
1,1,2-trichloroethane 0.150
trichloroethylene 0.180
bromoform 0.300
bromodichloromethane 0.300
chlorodibromomethane 0.300
xylenes 0.070
Meprobamate 400 +/- 20%
Atenolol 200 +/- 20%
Carbamazepine 1400 +/- 20%
DEET 1400 +/- 20%
Metolachlor 1400 +/- 20%
Trimethoprim 140 +/- 20%
Linuron 140 +/- 20%
TCEP 5000 +/- 20%
TCPP 5000 +/- 20%
Phenytoin 200 +/- 20%
Ibuprofen 400 +/- 20%
Naproxen 140 +/- 20%
Estrone 140 +/- 20%
Bisphenol A 2000 +/- 20%
Nonyl phenol 1400 +/- 20%
PFOA/PFOS 1.5 mg/L +/- 10%
49-1000586 Rev. 1
Influent challenge Maximum permissible
concentration product water
(mg/L) concentration (mg/L)
N/A
0.5
N/A
N/A
0.01
0.002
N/A
0.015 +/- 10% 0.003
0.015
0.001
0.003
0.001
0.001
0.0018
0.001
0.0002
0.0017
0.00002
0.001
0.001
0.0048
0.001
0.0005
0.001
0.001
0.001
0.0002
0.00059
0.001
0.00002
0.0005
0.0006
0.0002
0.0003
0.0001
0.0003
0.00001
0.0002
0.001
0.000002
0.00001
0.0001
0.001
0.004
0.0005
0.001
0.001
0.001
0.0016
0.001
0.0005
0.0046
0.0005
0.0010
0.015
0.015
0.015
0.001
60
30
200
200
200
20
20
700
700
30
60
20
20
300
200
0.07
Avg %
Reduction
Application Guidelines/Water Supply Parameters
> 99
Service Flow
> 99
Water Supply
91.4
Water Pressure
> 99.99
Water Temperature
98.85
Capacity
96.95
> 99
It is essential that the manufacturer's recommended installation,
86.95
maintenance and filter replacement requirements be carried out for the
> 99
product to perform as advertised. See Installation Manual for Warranty
> 98
information.
> 97
> 99
NOTE: While the testing was performed under standard
> 99
laboratory conditions, actual performance may vary.
98
Replacement Cartridge: RPWFE. For estimated costs of
> 99
replacement elements please call 1.877.959.8688 or visit our
99
98 website at cafeappliances.com/parts
> 99
> 99
WARNING
> 98
95
• Do not use with water that is microbiologically unsafe or
> 99
of unknown quality without adequate disinfection before
> 99
and after the system. Systems certified for cyst reduction
> 99
> 99
may be used on disinfected water that may contain filterable
> 99
cysts.
99
99
NOTICE
> 99
> 99 To reduce the risk of water leakage or flooding, and to
98
ensure optimal filter performance:
98
• Read and follow use instructions before installation and use
98
of this system.
98
• Installation and use MUST comply with all state and local
99
plumbing codes.
96
• Do not install if water pressure exceeds 120 psi (827 kPa).
> 99
98 If your water pressure exceeds 80 psi, you must install a
> 98
pressure-limiting valve. Contact a plumbing professional if
> 99
you are uncertain how to check your water pressure.
> 99
• Do not install where water hammer conditions may occur.
> 99
If water hammer conditions exist you must install a water
> 99
hammer arrester. Contact a plumbing professional if you are
> 97
uncertain how to check for this condition.
> 99
> 99
• Do not install on hot water supply lines. The maximum
> 99
operating water temperature of this filter system is 100º F
> 99
(38º C).
99
• Protect filter from freezing. Drain filter when temperatures
> 98
drop below 33ºF (0.6ºC).
> 99
• Change the disposable filter cartridge every six months or
95
> 99 sooner if you observe a noticeable reduction in water flow
> 99
rate.
95
• Failure to replace the disposable filter cartridge at
95
recommended intervals may lead to reduced filter
95
performance and cracks inthe filter housing, causing water
> 99
leakage or flooding.
> 99
• This System has been tested according to NSF/ANSI 42,
> 99
> 99 53, 401 and P473 for the reduction of the substances listed
> 99
below. The concentration of the indicated substances in
> 99
water entering the system was reduced to a concentration
> 99
less than or equal to the permissible limit for water leaving
> 99
the system, as specified in NSF/ANSI 42, 53, 401 and P473.
> 99
> 99
> 99
> 99
> 99
> 99
> 99
> 99
99.25
0.5 gpm (1.89 lpm)
Potable Water
25-120 psi (172-827 kPa)
33°F-100°F (0.6°C-38°C)
170 gallons (643.5 liters)
To reduce the risk associated with
ingestion of contaminants:
RPWFE System is certified by IAPMO
R&T against NSF/ANSI Standards 42,
53, 401, and P473 for the reduction of
claims specified on the performance
data sheet and at iapmort.org.
47