Cafe CFE Manuel D'utilisation Et D'installation page 31

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
Instructions for adjusting freezer door gaps:
IMPORTANT!
The 6 mounting screws (3 on each side) are NOT interchangeable with the center or top hinge screws.
Drawer screws have flat washer heads, and other screws have lines/ribs on washer heads.
After installation of the freezer door, check for uniform gaps (top and bottom of right and left hand side) with the
template provided.
In the event of excessive gaps use the following steps to adjust the freezer door.
Step 1 - Loosen the 3 screws on each side (right and left) of the freezer door.
Step 2 - Adjust set screw clockwise if gap at the top is too big (see template).
key clockwise by quarter to half a rotation
Step 3 - Adjust set screw counter-clockwise if gap at the bottom is too big (see template). Turn the set screw using
Step 4 - Tighten the 3 screws on each side (right and left).
Step 5 - Re-check the gaps using the template and repeat steps 1 to 4 if required and complete with step 5.
Fold here for using template
(1.5 cm)
Template for checking gaps.
or below.
Gabarit pour vérifier les écarts.
L'écart doit être de 0,6 po (1,5
cm) ou moins.
Plantilla para el control de
espacios. El espacio debería
Set Screw
Vis d'ajustement
Tornillo del Set
30
Plier ici pour utiliser le gabarit
Step 2
Étape 2
Paso 2
Dóblelo aquí para usar la plantilla
Step 3
Étape 3
Paso 3
Step 1
Étape 1
Paso 1
Step 4
Étape 4
Paso 4
49-1000586 Rev. 1