Electric Shock Hazard - Cafe CFE Manuel D'utilisation Et D'installation

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
CONNECTING THE REFRIGERATOR TO THE HOUSE WATER LINE
9
A cold water supply is required for automatic
ice maker operation. If there is not a cold water
supply, you will need to provide one. See
Installing the Water Line section.
NOTES:
• Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
• If your refrigerator does not have a water
filter, we recommend installing one if your
water supply has sand or particles that
could clog the screen of the refrigerator's
water valve. Install it in the water line near
the refrigerator. If using SmartConnect
Refrigerator Tubing Kit, you will need an
additional tube (WX08X10002) to connect the
filter. Do not cut plastic tube to install filter.
• Before connecting the water line to the house,
purge the house line for at least 2 minutes.
If you are using copper tubing, place a
A
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
If you are using the SmartConnect
nuts are already assembled to the tubing.
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
34
™
™ tubing, the
ELECTRIC SHOCK
HAZARD
Tubing Clamp
Tubing Clamp
Bride
Abrazadera del tubo
1/4" Tubing
Tuyau de 1/4 po
Tubería de 1/4
If you are using copper tubing, insert the end
B
of the tubing into the refrigerator connection, at
the back of the refrigerator, as far as possible.
While holding the tubing, tighten the fitting.
If you are using SmartConnect
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression nut
until it is hand tight. Then tighten one additional
turn with a wrench. Over tightening may cause
leaks.
Fasten the tubing into the clamp provided to
C
hold it in position. You may need to pry open
the clamp.
WARNING
Connect to potable water supply only.
A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals)
1/4" Compression
Nut
Ferrule
(sleeve)
OR
"
™ tubing,
SmartConnect ™
Tubing
Refrigerator
Connection
49-1000586 Rev. 1