Tools You Will Need; Materials You May Need - Cafe CFE Manuel D'utilisation Et D'installation

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
Anti-Tip Floor Bracket Installation (
WARNING
Some built-in style models (some CYE and CWE
models) are top heavy, especially with any doors
open. If an anti-tip floor bracket was included with
your refrigerator, install it to prevent the refrigerator
from tipping forward, which could result in death or
serious injury. Read and follow the entire installation
instructions for installing the anti-tip floor bracket
packed with your refrigerator.
NOTE:
If the anti-tip bracket included with your refrigerator
was damaged or lost, visit us online at
cafeappliances.com/parts to receive one at no cost.
In Canada, cafe.applances.ca/parts.
For installation instructions of the bracket, visit:
cafeappliances.com/literature. In Canada, cafe.
applances.ca/literature.

MATERIALS YOU MAY NEED

Lag Bolts
Drill Bit Appropriate for Anchors
For Anti-Tip Bracket Mounted on CONCRETE Floors Only
MEASURE CABINET
AT-1
OPENING AVAILABLE VS.
REFRIGERATOR WIDTH
Measure width of cabinet opening where
refrigerator will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
cm). The refrigerator will be placed approximately
in the middle of this opening.
Rear Wall
W
REFRIGERATOR
Front
32
If Required
Tip Over Hazard.
(not included)
Anchor Sleeves
Baseboard
Thickness or
Countertop
Overhang
(Whichever Is
Larger) Plus
Any Desired
RH Side
Clearance
)

TOOLS YOU WILL NEED

Electric or Hand Drill
Pencil
LOCATING THE ANTI-TIP
AT-2
FLOOR BRACKET
A
Place the anti-tip floor bracket locator template
(included inside the anti-tip kit) onto the floor
up against the rear wall, within W, and in line
with the desired location of the RH side of the
refrigerator (see Figure 1).
Figure 1 – Installation Overview
Floor – Concrete
(2 Holes)
Floor – Wood
(2 Holes)
B Place the anti-tip floor bracket onto the locator
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
of the sheet or the RH side of the refrigerator.
C Hold down in position and use the anti-tip floor
bracket as a template for marking the holes
based upon your configuration and type of
construction as shown in Step 3. Mark the hole
locations with a pencil, nail or awl.
NOTE:
mount the floor bracket (one on each side of
the anti-tip floor bracket). Both must be into
either the wall or the floor. Figure 2 indicates
all the acceptable mounting configurations for
screws. Identify the screw holes on the anti-tip
floor bracket for your configuration.
Tape measure
2 Wall Holes
Floor Bracket
to Install
RH Holes
Rear RH
Corner of
Cabinet Wall
RH Side of
Locator
Refrigerator
Template Sheet
49-1000586 Rev. 1