Rowenta REDKEN STEAM PRO Mode D'emploi page 6

EN
2) Tank
Your straightener can be used with tap water.
Removing and filling the reservoir : Do not pour water directly into the reservoir when it is fitted to its base.
Whenever you need to fill the reservoir you must first ensure that the cartridge is correctly in place in the reservoir,
disconnect the reservoir from the base (moving it horizontally), lift the filling cap and fill the reservoir up to its
maximum level. Reposition the reservoir on its base (moving it horizontally) until you hear the click sound.
IMPORTANT: Do not use any additives in the reservoir
What water should I use?
Your straightener has been designed to function using tap water.
Never use water which contains additives (starch, perfume, aromatic substances, softeners, etc.),
nor water from batteries or condensation (for example water from clothes dryers, water from refrigerators, from
air conditioning units or rain water).
This is because they contain organic waste or mineral elements which become concentrated under the effect of heat
and cause cracklings, brown colors or the premature ageing of your straightener. If your water is very hard,
we recommend you use a mixture 50 % tap water and 50 % demineralised water which you can get from the shops.
The straightener can be filled at any time.
It is important to always make sure that the level of water in the reservoir is above the minimum level indicated.
If the water level is lower than the minimum level, then there will be no more steam coming out of the straightener
and it won't work as well.
MAX
MIN
When using the straightener, you must be able to see steam coming out and hear the noise of the steam.
If you can't see any steam anymore and you can't hear the noise of the steam any longer either, this means that the
reservoir needs to be filled up. In this case, once you have filled the reservoir, you will need to wait for about 90 se-
conds before the steam starts coming out of the straightener again.
b
6
c
CLICK!
CLICK!
d