Rowenta REDKEN STEAM PRO Mode D'emploi page 9

• The iron should be stored in a safe, dry location, out of reach of children.
• If the cord of the iron is twisted, untwist the cord before use.
• Do not wrap cord around the handle unit.
• The appliance is for a commercial use.
If you want to empty water from the reservoir, first remove the resin cartridge.
Attaching / Removing / cleaning the comb.
If you want to clean the comb, you can remove it by following the diagram beneath.
Important, you must remove the comb when it's cold in order to avoid getting burnt.
The comb can be cleaned in soapy water. Check that the comb is dry before fitting it back on the straightener.
9. IF THERE'S A PROBLEM
MY HAIR IS NOT STRAIGHTENED CORRECTLY:
• Have you been using your straightener in the right direction?
(see paragraph 5. HOW TO START USING YOUR STRAIGHTENER, 1- direction of use).
• Did you choose the right temperature?
(take a look at the table showing the temperature settings)
• Is the straightener producing any steam? NO
• Did you fill the reservoir correctly (see paragraph on filling the reservoir page 14) ?
If the level is lower than the minimum level, fill the reservoir and close the tongs for around 90
seconds until the steam comes out.
• Have you positioned the reservoir correctly (see paragraph on removing and fitting the reservoir
page 14) ?
• Is the straightener at the right temperature? Wait until the figure representing the temperature
you have chosen has stopped flashing.
• Check that the steam cord hasn't accidentally become stuck.
THE STEAM CAN'T BE SEEN:
• In a very moist environment, it's possible that although you can't see the steam it is still producing the
required effect.
THE STRAIGHTENER WON'T HEAT UP:
• Have you checked that the straightener is not in economy energy mode? (see paragraph on economy
energy mode page 16).
• Have you plugged in your straightener and pressed continuously on the ON/OFF button to switch it on?
IF THE WATER DOESN'T GO TO THE BOTTOM OF THE RESERVOIR:
• It is possible that the resin cartridge is blocked up with impurities.
In this case, remove the cartridge, empty the reservoir and clean the top grill of the cartridge with some
9
EN