Functional Overview; Power Section - Philips HD 1500 Mode D'emploi

XP SBC HD 1500/17 for USA 14-01-2004 13:34 Pagina 15

Functional overview -

Product illustrations on inside flap
Base station front panel (figure 1)

1 Power section

2 Source select section
3 The input signal detection section
a) power on/standby and demo mode button
By holding the 'STANDBY-ON' button for 1.5 seconds or
longer, the demo mode can be activated:
– Pink noise is used to simulate the position of the 5 virtual
speakers in the headphone.
– The corresponding speaker indicator in the output section
of the display will go on indicating which speaker is being
simulated.
The demo mode can be deactivated by pressing any control
button on the base station.
b) STANDBY-ON' dual-color LED
– Red = base station in standby mode
– Green = base station in active mode
c) CHARGE' indication dual-color LED
– Red = low-rate charging in progress
– Green = trickle charging in process
– Off = battery compartment empty
a) button to toggle between the analogue and digital coaxial inputs
b) 'Source' menu yellow LED
c) 'ANALOG' indication green LED
d) 'DIGITAL' indication illuminated by dual colour LED:
– Red = input signal is locked, but invalid
(for instance 96 kHz) or unlocked (no signal)
– Green = input signal is locked and valid (signal accepted)
a) 'STEREO' indicator green LED (activated in case of detection of
digital stereo signal or selection of analogue input source)
b) 'DTS' indicator green LED (activated in case of detection of DTS
signal)
c) 'MULTICHANNEL' indicator green LED
(activated in case of detection of multi-channel audio)
d) 'DOLBY DIGITAL' indicator green LED
(activated in case of detection of Dolby Digital signal)
ENGLISH 15