Install The Squeegee; Fill The Solution Tank - Nilfisk Advance SC1500 Mode D'emploi

INSTALL THE SQUEEGEE

1 See Figure 4. Squeeze the back of the Squeegee Mount Bracket (AA) to open and release the bracket once it's in place over the deck arm Pins (AB).
2 Connect the Recovery Hose (AC) to the squeegee inlet.
3 Lower the scrub deck and squeegee, move the machine ahead slightly. If necessary adjust the rear squeegee height using the Rear Caster Wheel (AD) so
that the rear squeegee blade touches the fl oor evenly across its entire width and is bent over slightly as shown in the squeegee cross section (AE).
FIGURE 4

FILL THE SOLUTION TANK

Read the cleaning chemical label and calculate the proper amount of chemical to mix for a tank that holds 12 US gallons (45 liters).
Open the Solution Tank Fill Cap (5) or the Solution Tank Rear Fill Port (17), then fi ll the tank 1/3 full of water, add the cleaning chemical, then fi ll up the tank the
remainder of the way. The amount of solution in the tank can be observed by looking at the Solution Tank Level Sight Tube (31).
CAUTION!
Use only low-foaming, non-fl ammable liquid detergents intended for automatic scrubber machine applications. Water temperature
should not exceed 130 degrees Fahrenheit (55 degrees Celsius).
5/2014
INSTRUCTIONS FOR USE
AB
56091120 - SC1500
AA
AC
AD
ENGLISH - A
AE
A - 13