Instructions For Use; Unpacking; Know Your Machine; Nameplate - Nilfisk Advance CA 450 Manuel D'emploi Et D'entretien

INSTRUCTIONS FOR USE

Before using the machine make sure that the frequency
and voltage shown on the rating plate correspond with the
mains voltage.
This manual will help you get the most from your Nilfisk CA
450/530. Read it thoroughly before operating the machine.
This product is intended for commercial use only.
Specifications and details are subject to change without
prior notice.

UNPACKING

When the machine is delivered, carefully inspect the
shipping carton and the machine for damage. If damage is
evident, save the shipping carton so that it can be
inspected by the carrier. Contact the carrier immediately to
file a freight damage claim.

KNOW YOUR MACHINE

1. Display
2. Brush switch
3. Vacuum switch
4. Solution flow control lever
5. Start/Stop drive panel
6. Squeegee raise/lower handle
7. Brush raise/lower pedal
8. Recovery tank
9. Recovery tank automatic float shut off
10. Pre-filter turbine
11. Solution tank
12. Vacuum motor
13. Brush motor
14. Traction control knob
15. Brush
16. Squeegee assembly

NAMEPLATE

The Model and Serial Number of your machine are shown
on the nameplate on the machine. This information is
needed when ordering repair parts for the machine. Use
the space below to note the Model and Serial Number of
your machine for future reference.
Model ...........................................................................
Serial Number ..............................................................
08812381(3)2004-05 A
USE AND MAINTENANCE MANUAL

PREPARE THE MACHINE FOR USE

INSTALLING THE BRUSH OR PAD
HOLDER
WARNING!
Moving parts - disconnect the power supply
connection before servicing.
WARNING!
If using a pad, install the pad on the
padholder first.
Raise the brush deck in the upper position.
Place brush/padholder under the raised
brush deck.
Lower the brush pedal.
Turn brush motor ON.
Touch the drive panel quickly so that the
brush/padholder is engaged.

INSTALL THE SQUEEGEE

1. Install the squeegee assembly onto the squeegee
bracket.
2. Tighten the thumb nuts securely.
3. Attach the squeegee hose to the squeegee assembly.

FILL THE SOLUTION TANK

1. Fill the solution tank with a cleaning solution
appropriate for the job.
2. Do not overfill the solution tank
3. Always follow the dilution instructions on the chemical
container label.
4. The temperature of the cleaning solution must not
exceed 40°C.
CAUTION!
Use only low-foaming, non-flammable liquid
solutions intended for automatic scrubber
applications.
3