General Guidelines - Ayrton IceColor 250 Manuel D'utilisation

If the device has been exposed to temperature changes due
to environmental changes, do not switch it on immediately.
The arising condensation could damage the device. Leave
the device switched off until it has reached room temperature.
This device falls under protection-class I.
Therefore it is essential that the device should be earthed.
The electric connection must carry out by qualified person.
No move at operating mode.
If the external flexible cable or cord of this luminaire is
damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualified person in order to
avoid a hazard.
Make sure that the available voltage is not higher than stated
at the end of this manual.
Make sure the power cord is never crimped or damaged by
sharp edges. If this would be the case, replacement of the
cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not
in use or before cleaning it. Only handle the power cord by
the plug. Never pull out the plug by tugging the power cord.
Fixtures cannot be installed on combustible substances,
keep more than 50cm distance with wall for smooth air flow,
so there should be no shelter for fans and ventilation for heat
radiation.
CAUTION !
PROJECTOR USING CLASS 2 LED SOURCES
(EN60625-1 : 1994)
This device uses multiple high-power (CLASS 2) LED
(Light Emitting Diode) light sources.
If the external flexible cable or cord of this luminaire is
damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualified person in order to
avoid a hazard.
If the external flexible cable or cord of this luminaire is
damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualified person in order to
avoid a hazard.
CAUTION !
Never touch the device during operation !
The housing may heat up.
Please be aware that damages caused by manual
modifications to the device are not subject to warranty. Keep
away from children and non-professionals.

General guidelines

This device is a lighting effect for professional use on stages,
in discotheques, theatres, etc., the device was designed for
indoor and outdoor use.
This fixture is only allowed to be operated with the max
alternating current which stated in the technical specifications
in the last page of this manual.
Lighting effects are not designed for permanent operation.
Consistent operation breaks may ensure that the device will
serve you for a long time without defects.
Do not shake the device. Avoid brute force when installing or
operating the device.
While choosing the installation-spot, please make sure that
the device is not exposed to extreme heat, moisture or dust.
Please don't project the beam onto combustible substances.
The minimum distance between light-output from the
projector and the illuminated surface must be more than 0.2
meter.
If you use the quick lock cam in hanging up the fixture, please
make sure the quick lock fasteners turned in the quick lock
holes correctly.
Operate the device only after having familiarized with its
functions. Do not permit operation by persons not qualified
for operating the device. Most damages are the result of
unprofessional operation.
Please use the original packaging if the device is to be
transported.
For safety reasons, please be aware that all modifications on
the device are forbidden.
If this device will be operated in any way different to the one
described in this manual, the product may suffer damages
and the guarantee becomes void. Furthermore, any other
operation may lead to short-circuit, burns, electric shock,
lamp explosion, crash, etc.
USER MANUAL 5
CAUTION !
Never look directly into the light source, as
sensitive persons may suffer an epileptic shock.