Attaching The Caster Wheels; Assembling The Cart; Completing The Cart; Lifting The Ceramic Body Onto The Cart - Pit Boss PBK22 Manuel D'instructions

1

ATTACHING THE CASTER WHEELS

Attach the four pre-threaded caster wheels (2 & 3) to each of the four
brackets (1) by hand-tightening them into the hole.
3
1
Secure caster wheels with large nut (B). To keep support brackets
level, ensure the bolt on the wheel does not extend the large nut.
3
2

ASSEMBLING THE CART

To assemble the cart, attach the two crosspieces (4) to one of the four
brackets (1). Secure the brackets (1) to the crosspieces (4) by using the
16x bolts, washers, locking washers, and nuts (A,C,D,E). Please note
the position shown in the diagram.
4
1
E
A+C+D
8
3

COMPLETING THE CART

Continue to attach the crosspieces (4) into the other three support
brackets (1). The cart is now complete.
4

LIFTING THE CERAMIC BODY ONTO THE CART

Make sure the cart is secure, and all of the bolts are tight before
placing the ceramic body (9) into it. Press down on the caster levers
B
(2) to lock the castor wheels to ensure the ceramic charcoal barbecue
cannot move.
To place the ceramic body (9) on the cart, first remove all of the items
that are inside of the grill to make lifting easier. Place one of your
hands in the bottom vent of the ceramic body and the other under
the grill.
CAUTION: Use a minimum of two people when lifting the ceramic
body onto the cart. Lifting by the hinge or the side tables could result
in injury and damage to the product.
Place the ceramic charcoal barbecue on the cart with the bottom
vent facing to the front of the cart allowing the vent to open and
close without any interruption.
9