Installing The D-Air Street Smart Jkt In The Specifically Designed Garment; Transportation - DAINESE D-AIR STREET SMART JKT.1 Notice D'utilisation

TABLE 6: LIST AND MEANING
OF INTERNATIONAL CARE SYMBOLS
ON THE LABEL AFFIXED
TO THE DEVICE
1 - THIS GARMENT
CANNOT BE WASHED
IN WATER
WARNING!
Do not immerse the D-AIR STREET SMART JKT in water or
other liquids.
Immersing the D-AIR STREET SMART JKT in water or other
liquids could cause irreparable damage to the electronic
components of the System.
Do not iron the D-AIR STREET SMART JKT
Do not wash under running water.
Do not use solvents or other chemical substances for cleaning.
Do not paint the protective device, or use dyes of any kind
on it.
Avoid exposure to direct sunlight as much as possible.
Do not expose the device to high or low temperatures.
Never tamper with any part of the device.
Do not bend or twist the device as these actions constitute
improper use for which the item has not been designed; in
fact, this could cause loss of its protective properties or
68 I N F O R M A T I V E N O T E F O R I N F L A T A B L E
2 - THIS GARMENT 4 - THIS GARMENT
CANNOT BE TREATED CANNOT BE DRY
WITH CHLORINE CLEANED
5 - THIS GARMENT
3 - THIS GARMENT
CANNOT BE TUMBLE
CANNOT BE IRONED
DRIED
breakage. Therefore, Dainese shall not accept complaints or
requests for replacement of devices that it finds have been
used improperly.
When not in use, the device must be stored in a dry and
well ventilated place where it is not subjected to impact or
pressure.
Avoid storing the device with its weight concentrated in only
a few points.
If the D-AIR STREET SMART JKT is integrated in a garment
that is NOT waterproof, in the event of rain protect the System
with a rainproof jacket worn over this garment.
After use, if necessary leave the device to dry in a ventilated
place at room temperature; do not use hair dryers or other
heating devices.
P R O T E C T O R S
4.5. INSTALLING THE D-AIR STREET SMART JKT IN THE
SPECIFICALLY DESIGNED GARMENT
To install the D-AIR STREET SMART JKT refer to the
instructions in Chapter 2.6.

4.6. TRANSPORTATION

Store and transport the device using the bag provided at
the time of purchase.
WARNING!
Always make sure that the system is placed in shipping
mode to prevent the system from being switched on
accidentally during transportation.
Always make sure that the switch-on/switch-off button
of the protective device has been opened correctly to
prevent accidental contact of the button which could
cause the System to be switched on.
Due to the presence of the gas generator and related
triggering system, air transport might be prohibited or
subject to special transport procedures. Before shipping
your garment with the D-AIR STREET SMART JKT
integrated by air, check with the airport authorities and
with the airline to find out the correct procedure to follow.
D - A I R ® S T R E E T S M A R T J K T
69