2
Before getting onto the motorcycle, check
correct operation of the system indicated by a
steady blue LED (see user interface chapter). In this
condition, the system is operating correctly but is
NOT activated and therefore does NOT protect the
chest.
FIGURE 4: SEQUENCE INDICATING THAT THE SYSTEM
IS OPERATING CORRECTLY BUT IS NOT ACTIVATED
42
I N F O R M A T I V E
N O T E
F O R
3
Before starting out using the D-AIR STREET
SMART JKT always check that the system has
correctly identified the GPS signal or the vehicle
vibrations (steady green LED), as the System will
only operate correctly and be activated in this
condition.
FIGURE 5: SEQUENCE INDICATING THAT THE SYSTEM
IS OPERATING CORRECTLY AND IS ACTIVATED
I N F L A T A B L E
P R O T E C T O R S
4
After you have finished using the System, deactivate
the D-AIR STREET SMART JKT immediately by
opening the switch-on/switch-off button. During
transportation, place the system in shipping mode.
WARNING!
When the System is not in use, always make sure
that the button do not close the contact. In the
event of unintended contact causing switch-on,
the system could be triggered accidentally during
transport.
3.3.1. CHECKING CORRECT FUNCTIONALITY OF
THE SYSTEM
Always check System functionality before use. Use
of the system when signs of anomaly appear must
be considered as being performed at the user's own
risk.
After putting on the System, switch it on and step
outside where the GPS signal can be correctly
received. When you see a single steady blue LED
signal, this means that the System is ready for use.
For more details, check the flashing codes in the
previous paragraph "Guide to user interface LED
sequences during use".
WARNING!
Before using the D-AIR STREET SMART JKT always
make sure that the System has correctly identified
the GPS or identified the vehicle vibrations (steady
green LED), as the System will only be activated in
these cases.
43
D - A I R ®
S T R E E T
S M A R T
J K T