Cold-Starting - Ammann AVP 1240-2 Traduction Du Mode D'emploi Original

3.5.3 Cold-starting

In cold weather, when the engine is hard to start:
5
L 40_007.cdr
– Remove the rubber plug (5) of the rocker arm cover and
L 40_008.cdr
– add 2 cc of engine oil.
Never use any cold-starting aids such as ether,
gasoline, paint thinner or other volatile liquid or
gas.
Attention
– Keep the rubber plug (5) in the cover.
If the plug is not in place, rain, dirt and other con-
taminants may enter the engine and cause accel-
erated wear of internal parts. This can cause seri-
Attention
ous problems. Severe damage to the engine will
occur.
– Starting the engine (Paragr. 3.5.1)
3.5.4 Switching of the engine
STOP
L 40_006.cdr
– Adjust engine speed control lever (2) to idle position.
– Allow the engine to warm up for 2 ... 3 minutes.
2
STOP
– Adjust engine speed control lever (2) to «STOP».
If the engine keeps on running even after the speed le-
ver is placed at the «STOP»-position, stop the engine
either by closing the fuel cock («S»-position) or by
Important
loosening the nut (6) of the high-pressure fuel pipe on
the pump side.
1
– Set the fuel cock lever (1) to the «S»-position (closed).
46
3. Operation
2
SLOW RUN
6
SLOW RUN
L 40_009.cdr
S
L 40_010.cdr