Philips HP6581 Mode D'emploi page 10

EnglisH
10
Epilating the legs with the epilator
- If you already have some experience with epilation, you can simply use
the epilating head with the basic epilation cap.
- If your hairs lie flat on your skin, we advise you to use the active hair-
lift and massage cap. This cap not only lifts up the hairs but its active
massaging roller also minimises the pulling sensation of epilation.
Note: Remove the basic epilation cap (1) before you attach another cap (2).
1 Put the cap on the epilating head.
2 Press the on/off button once to switch on the appliance.
The appliance starts to operate at speed II, which is the most
,
efficient speed for epilating.
Note: If you want to use speed I, press the on/off button a second time.
Note: Speed I is suitable for areas with little hair growth and for hard-to-reach
areas, such as knees and ankles.
3 Stretch the skin with your free hand to make the hairs stand upright
(1). Place the epilating head at an angle of 90° onto the skin with
the on/off button pointing in the direction in which you are going to
move the appliance (2).
4 Slowly move the appliance over the skin against the direction of the
hair growth while pressing it lightly.
Tip: To relax the skin, we advise you to apply a moisturising cream immediately
or a few hours after epilation. For the underarms, use a mild deodorant without
alcohol.