Quick Start; Menu Operation - DeFelsko PosiTector 200 Guide D'utilisation

The PosiTector 200 is a hand-held Coating Thickness Gage
that uses a non-destructive ultrasonic principle to measure
coating thickness on a wide variety of substrates. It consists of
a body (Standard or Advanced) and a probe (see Probes pg. 2).
This Quick Guide summarizes the basic functions of the Gage.
Download the full instruction manual at:
www.defelsko.com/manuals
The PosiTector 200 powers-up when the center navigation
button is pressed. To preserve battery life, the instrument
powers down after approximately 5 minutes of no activity.
All settings are retained.
1. Remove the protective rubber cap from the probe.
2. Power-up Gage by pressing the center navigation
3. Zero the probe. (pg. 5)
4. Adjust to a known thickness, if necessary. (pg. 6)
5. Apply couplant (pg. 2) to the surface of the part.
6. Measure the part. (pg. 3)
Gage functions are menu controlled. To access the Menu,
power-up the gage, then press the center navigation button.
Center Navigation Button
Up
Center
Down
Select Exit to exit from any menu.
Introduction

Quick Start

Menu Operation

To navigate, use the Up and Down buttons to
scroll vertically and
Press the (+) button to switch pages in a
multipage menu. Press the (-) button to
return to the previous menu or page
1
button.
to SELECT.