SOMFY SOLUS P&P Notice page 18

Problems
The roller shutter
does not stop when
it reaches the upper
end limit position.
2. 4. 2.
2. 4. 2. 1. Using the control point connected to the roller shutter
Place the roller shutter in the mid-height position.
1)
2)
Press the Up button until the roller shutter moves.
•
Release the button immediately.
3)
Press the Down button until the roller shutter moves.
•
Release the button immediately.
Press the Down button again until the roller shutter
4)
makes 2 successive movements in the same direction.
•
2. 4. 2. 2. Using the wired electronic motor setting tool
Press the Up and Down buttons on the setting tool at the
-
same time until the roller shutter makes two successive
up and down movements.
The drive has been restored with the original
•
Copyright © 2017 Somfy SAS. All rights reserved.
Possible causes
The roller shutter locking
system in the upper position
is not correct.
Solutions
with end stops screwed onto the
incorporated in the runners or an end
slat acting as an end stop.
1
3
x 2
7s
Images not contractually binding
EN
2
x 3
4
17