SOMFY SOLUS P&P Notice page 16

2. 1. 3. Drive/tube assembly
Slide the motor into the roller tube.
1)
For roller tubes which are smooth inside, position the
notch previously cut on the boss on the crown.
The drive wheel must be locked in place to prevent it
2)
moving along the roller tube:
•
5 mm to 15 mm from the outer rim of the drive wheel,
regardless of the roller tube.
The screws or pop rivets must only be attached to the
drive wheel and not to the motor.
Alternatively, a drive wheel stop can be used for tubes
•
which are not smooth.
Secure the tube end piece onto the roller tube.
3)
2. 1. 4. Installing the drive/tube assembly
1)
bracket f and onto the drive bracket g:
Ensure that the drive/tube assembly is secured
onto the end bracket. This operation prevents the
drive/tube assembly from coming out of the end
bracket mounting when the roller blind reaches the
lower end limit position.
2)
place.
2. 2. WIRING
Cables crossing a metal wall must be protected and
insulated using a sheath or sleeve.
Attach cables to prevent any contact with moving
parts.
If the drive is used outdoors, and if the supply cable is
gland.
The SOLUS P&P cable cannot be removed. If it is damaged, return the drive to the After-
Sales department.
Always make a loop in the power supply cable to prevent water entering the drive!
Switch off the mains power supply.
-
Connect the drive in accordance with the information in the table below:
-
230 V 50 Hz
Neutral (N) Blue
Phase (L1) Brown
Phase (L2) Black
Earth ( ) Yellow/Green
Copyright © 2017 Somfy SAS. All rights reserved.
Cable
1)
2)
3)
1)
g
2)
h
h in
OFF
Images not contractually binding
EN
15 mm
5 mm
L1
20 mm
f
L ≤ 50 m
L1
N
L2
L
15