How To Treat - Tria 4X Instructions D'utilisation

HOW TO TREAT

1. TURN ON THE LASER, UNLOCK IT
AND SET THE TREATMENT LEVEL
(SEE PAGES 16-17).
18
2. TOUCH AND HOLD THE TREATMENT
WINDOW TO THE SKIN UNTIL YOU
HEAR TWO BEEPS.
•
If you do not hear beeps, make sure that
the treatment window is flat against your
skin. The laser will only pulse when the
whole window is touching your skin.
•
If you hear a buzzing tone instead of the
second beep, you lifted the device from
the skin before the pulse was over.
•
Do not move the treatment window
between the first and second beep because
this will disrupt the laser pulse and reduce
its effectiveness.
3. LIFT THE LASER AND PLACE IT BACK
ON THE SKIN SO THAT IT OVERLAPS
THE PREVIOUS SPOT.
•
Each time you reposition the treatment
window, move it about half the distance
of the window (about 1/4 inch or 5 mm).
This creates an overlapping pattern in the
treatment area, which ensures you cover
all the hair follicles. This works out to about
25 laser pulses per square inch or
40 pulses per 10 square cm.
DO NOT treat repeatedly in the same
spot. Always move the treatment window
to a new area after each laser pulse. Failure
to do so may result in discomfort or skin
heating, which could cause skin injury.
cause skin injury.
triabeauty.ca 19