Dometic PERFECTROOF PR2000 Notice D'utilisation page 24

Cleaning and maintenance
8.3 Checking
!
WARNING!
Do not use the awning if any settings or maintenance work are required.
If you discover any damage, please contact the service agent in the
respective country (see dometic.com).
1. Check the awning regularly for any imbalance and wear, as well as damage to
major parts.
2. Check the awning regularly:
– Is the fabric free of damage?
– Are the arms and front panel free of damage with no signs of wear?
– Does the awning close properly?
I
NOTE
Dometic accessories such as sealing joints or foam strips are subject to
environmental wear and tear. This is not an evidence of poor quality.
To ensure the function of these parts, Dometic recommends replacing
rubber seals and foam strips every 5 years.
8.4 Tightening the screws on the hinges
The screws on the hinges must be tightened up after being used for the first time:
• after the first holiday using the awning
• after driving 20000 km or six months after the awning was mounted
(whichever occurs first)
The screws on the hinge also need to be checked during the routine vehicle
inspection.
Contact your service agent to tighten up the screws.
Instructions for servicing (fig. i, page 11)
A
NOTICE!
The awning arms must not bear any load. This is to prevent the fastening
torque of the screws from being distorted.
1. Lift up the front panel slightly so that the hinge does not bear any load.
2. Tighten the screws with 15 – 25 Nm.
24
PR2000, PR2500
EN