Dometic PERFECTROOF PR2000 Notice D'utilisation page 20

Operating the awning
6. Fold the lever for the strut up to secure the struts (fig. 8, page 7).
7. Extend the other strut in the same way.
8. Press the button
extended to the required position. Position the struts vertically and back under
the front panel every 30 cm so that the awning stays secured at all times.
9. Press the switch
retracted far enough to tauten the fabric.
A
NOTICE! Beware of damage.
The fabric of the awning should not hang down at the edges, and must
remain taut at all times. If the fabric hangs down, it could rub against the
arms and become damaged.
The fabric used for long awnings should not sag in the middle.
Positioning the struts on the ground
!
WARNING! Beware of injury
• Only position the struts on solid ground.
• Secure the struts from slipping.
1. Position the struts vertically underneath the front panel.
2. Secure the struts with pegs (fig. 9, page 7).
3. Position one of the struts slightly deeper so that the front panel hangs at an
angle. This allows rain to run off more easily (fig. 0, page 7).
Securing the struts on the vehicle
You can secure the awning on your vehicle directly if you have already mounted the
latches for the struts.
1. Slide the cover of the latch up (fig. a, page 7).
2. Fit the strut into the latch (fig. a, page 7).
3. Slide the cover of the latch down (fig. a, page 7).
4. Position one of the struts slightly deeper so that the front panel hangs at an
angle. This allows rain to run off more easily (fig. b, page 8).
Mounting the tension rafter (fig. c, page 8)
Awnings with a length of 4 m or more need to have a tension rafter fitted in the
middle of the awning. This prevents the awning from sagging.
1. Slide in the tension rafter.
20
of the switch or the remote control until the awning is
of the switch or the remote control until the awning has
PR2000, PR2500
EN