Operating the awning
Controls of the switch (only PR2500 as motor version)
No. in fig. 1,
page 3
1
2
3
7
Operating the awning
Observe the safety instructions in chapter "Safety instructions" on page 13.
7.1
Note on the vehicle location
A
NOTICE!
• Park the vehicle so that no debris (branches, leaves or similar) gets on
to the fabric.
• Keep the awning free of dirt to prevent abrasions, stains and mildew.
7.2
Extending the awning
Extending the hand crank version
!
WARNING! Beware of injury.
Keep a sufficient distance from objects or other vehicles. Once it is
retracted, it should be at least 40 cm away from other objects and
vehicles on all sides.
1. Click the hand crank into the holder in the awning (fig. 2, page 3).
2. Turn the hand crank until the awning is extended by about 1.5 metres (fig. 3,
page 4).
3. Push the right strut in the front cover together so that you can move it freely
(fig. 5, page 5).
4. Turn the right strut to the side (fig. 5, page 5).
5. Fold the right strut down and set it on the ground (fig. 6, page 6).
6. Adjust the strut to the required height (fig. 7, page 6).
7. Fold the lever for the strut up to secure the struts (fig. 8, page 7).
18
Description
Retract awning
Stop
Extend awning
PR2000, PR2500
EN